Specifications of rebar bending machines mainly include parameters such as equipment size, weight, power requirements, bending radius, bending angle and bending speed.
Basic parameters of equipment
Equipment size: The size of the rebar bending center varies depending on the model. The common equipment width is usually between 2 meters and 3 meters, the length is between 5 meters and 10 meters, and the height is between 1.5 meters and 2.5 meters. The specific size should be selected according to the actual needs and space limitations of the construction site.
Equipment weight : The weight of the rebar bending center also varies depending on the model, generally between 2 tons and 5 tons. Heavier equipment usually means more stable and durable, but it will also be more difficult to move and install.
Power requirements: The rebar bending center generally uses a three-phase four-wire power supply with a voltage requirement of 380V±10% and a frequency of 50Hz. The power cord should have sufficient cross-sectional area to ensure the stability of the equipment operation.
Equipment performance parameters
Bending radius: The bending radius of the rebar bending center refers to the minimum radius that the equipment can bend. Different equipment models and different bending molds have different minimum bending radius. Generally speaking, the smaller the bending radius, the higher the flexibility of the equipment.
Bending angle: The rebar bending center can adjust the bending angle as needed. Common bending angles are 90 degrees, 135 degrees, 180 degrees, etc. Some high-end equipment also supports fine-tuning functions to accurately control the bending angle.
Bending speed: The bending speed of the rebar bending center refers to the number of bends that the equipment can complete per minute. Generally speaking, the faster the bending speed, the higher the production efficiency of the equipment, but too fast a bending speed may affect the bending quality.
Equipment safety parameters
Protective device: The rebar bending center should be equipped with complete protective devices, such as protective covers, protective nets, etc., to prevent splashes generated during operation from injuring people.
Emergency stop button: The equipment should be equipped with an emergency stop button to quickly cut off the power supply in an emergency to protect the safety of the operator.
Electrical safety: The electrical system of the rebar bending center should comply with relevant national standards, and all